Dunmowin

After travelling the Oodnadatta Track (and all accepted corrigatgions) we found the jet to our thetford toilet seemed to have disappeared. We had this repaired in Adelaide, but had since happened again when on another corrigated road off the Eyre Highway. also have found top and second drawer hinges have come "unstuck" and catches are breaking. Any thoughts on these Currently in Kalgoorlie

Have a SMEV 401 installed in my Kedron caravan. Have never been happy with the heat in the oven. Apparently Mark 4 = 180 degrees, but have had the oven cranked up to mark 6 with thermometer in the oven and temp has not gove over 150 Any suggestions?

Does anyone have issues with the standard flexible rubber radio aerial that kedron fit on their vans? We have found in areas of "vague" reception, that ours is of no use at all, whereas, the aerial on the 4WD works fine. Any ideas on replacement or alternative?

I have a 2003 Nissan Patrol 4.2 ltr turbo diesel. I am towing a Kedron ATV 21foot. At present I have slightly heavier springs but not sure what they are as they were on the vehicle when I purchased it.I have Level riders on the van.. Also air bags on the patrol.And these are my problem as they keep going down. When I tow with them low of preasure I sure notice the differience,so I want to replace them. My question is.....what is best. replace the air bags only....... get heavier springs and forget the air bags.....or replace both springs and air bags. We are on the road permenently and cover many miles some weeks. But there are times when we like an area we stay put, so I am thinking that the air bags are the way to go.What is the general oppinion of air bags ? singed DUNMOWIN....curently in Boulia QLD after a week at the Birdsville Races.

Hi there, we are working at the races this year. jut wondering how many kedrons will be there - We we are currently in Isisford, travelling to Longreach, then down through Windorah before reaching Birdsville. Have only seen two or three since leaving Brisbane in early July Dunmowin currently in Isisford

Thanks Danny, looks like a plug in timer is the way to go Dunmowin Currently in Blackwater

We have a 21ft ATV, which we normally run off 12v, however, when we do run on power (240v)we notice at night that the power supply(which is directly under the head of our bed) hums whenever the vitro fridge starts up which is regularly throughout the night. WE have temporarily solved this by switching over to 12v at night, does anyone have any other suggestions? regards "Dummowin" currently in Barcaldine

Hi there, have just stumbled across this forum, and though I would share . We picked up our new ATV in February, and are now "itching" to make the plunge to start the block. Only stumbling block at the moment is waiting for the house to sell..... Not a happy market at the moment. regards Dunmowin