HAVAGO Posted March 9, 2017 Report Share Posted March 9, 2017 (edited) Can anyone shed some light on how to remove these bulbs please. Thanks in advance for assistance. Edited March 10, 2017 by HAVAGO Quote Link to comment Share on other sites More sharing options...
Grahame and Wendy Roberts Posted March 9, 2017 Report Share Posted March 9, 2017 Greg, You will have to be more specific than that mate - which light bulbs? If you are referring to the LED indicator panels at the back of Kedron van models over three years old see my posting for removal of the plastic trim and replacement of the LED modules on this forum. Regards, Grahame Quote Link to comment Share on other sites More sharing options...
HAVAGO Posted March 10, 2017 Author Report Share Posted March 10, 2017 Sorry i did add picture but for some reason not showing. Will try again. The lights are above the seating area. Quote Link to comment Share on other sites More sharing options...
Merv and Di Posted March 10, 2017 Report Share Posted March 10, 2017 Hi Havago The globes look like they are similar to the 50 watt halogen two pin push in type, if that is the case they should simply pull out with a little care. Otherwise the G type globes that will turn to either left or right then pull out. Try a little upward pressure then try to turn one way or the other. Cheers Merv Quote Link to comment Share on other sites More sharing options...
HAVAGO Posted March 10, 2017 Author Report Share Posted March 10, 2017 (edited) Hello Merv, Yes the one beside the beds we turned the front plastic black covers and it came off exposing the bulb which easily pulled out, two pin globe. The ones above the seating I cant get the front off, tried turning left and right slightly pushing in and to no avail. I am obviously missing something, probably so simple once realised LOL I appreciate your response. Greg Edited March 10, 2017 by HAVAGO Quote Link to comment Share on other sites More sharing options...
HAVAGO Posted March 10, 2017 Author Report Share Posted March 10, 2017 Hello Merv, Yes the one beside the beds we turned the front plastic black covers and it came off exposing the bulb which easily pulled out, two pin globe. The ones above the seating I cant get the front off, tried turning left and right slightly pushing in and to no avail. I appreciate your response. Greg Quote Link to comment Share on other sites More sharing options...
Bas Posted March 11, 2017 Report Share Posted March 11, 2017 Hi Greg, removing the ones pictured is a challenge. On the round section there is a tiny hole and using a fine screwdriver push the piece of plastic slightly protruding. The complete light assembly can then be removed. The light section inside can then be removed, although it is a bit of a learn as you go exercise and fiddly is an appropriate description. I replaced the first bulb that blew with an LED, and they are available in both warm and cool white. I chose cool as the light produced is much "cleaner', but the preference is a personal one. Take the old bulb with you when buying the replacement as there are different diameters and pin sizes. The LED lasted probably 12-18 months with a fair bit of use and when I mentioned to the LED specialist that I expected greater life, he enquired if the bulb was enclosed (which it is) and so recommended to provide a bit of air flow if possible. The "gold" surround is plastic so I drilled a 13mm hole at the back where it cannot be seen when I was replacing the bulb. Time will tell if this helps with bulb life. Hope this helps. Barry Quote Link to comment Share on other sites More sharing options...
HAVAGO Posted March 11, 2017 Author Report Share Posted March 11, 2017 Hello Barry, Very much appreciated, I didn't see that little slot in the rear. Too busy trying to get the front cover of the bulb. I appreciate your response and will follow your advice to the letter. All good now thanks kindly. Regards Greg Quote Link to comment Share on other sites More sharing options...
HAVAGO Posted March 11, 2017 Author Report Share Posted March 11, 2017 1 hour ago, Bas said: Hi Greg, removing the ones pictured is a challenge. The light section inside can then be removed, although it is a bit of a learn as you go exercise and fiddly is an appropriate description. What you said above, So very true. Job completed. Thanks again Barry. Cheers Greg 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.